Mossari Long-Lasting Self-Watering Planter Setup

Your Mossari planter uses a simple wicking system to draw water from the lower reservoir into the substrate as the plant needs it. Depending on the plant, environment, and reservoir size, it can last 30 days or longer between refills.

All Mossari standalone self-watering planters assemble the same way, even though the outer shapes may vary.

Watch the Setup Video

[Embed setup video here]

What Is Included

• Upper planter
• Lower water reservoir
• Wicking cord

How to Assemble Your Planter

1. Insert the Wick

Thread the wick through the center hole in the upper planter. Tie a loose overhand knot and leave several inches of wick extending upward inside the planter.

The wick should reach near the top of the soil or root zone. This helps distribute moisture throughout the substrate instead of only keeping the bottom layer wet.

2. Add Substrate and Your Plant

Add your preferred substrate and plant to the upper planter.

As you fill the planter, keep the upper portion of the wick extending upward through the substrate so that it reaches close to the plant’s root zone.

3. Fill the Water Reservoir

Fill the lower reservoir with water.

You can also add diluted liquid plant food to the reservoir if needed. If feeding through the reservoir, start with a mild solution, such as approximately quarter strength, to reduce the risk of overfertilizing.

4. Assemble the Planter

Set the upper planter into the lower reservoir. Make sure the wick hangs down into the water.

The wick will gradually draw water upward through capillary action, helping the substrate stay evenly moist.

Important First-Watering Step

After planting, water from the top once and allow any excess water to drain into the reservoir.

This saturates the substrate and jump-starts the wicking process.

Refilling the Reservoir

Check the water level periodically and refill the reservoir when it gets low.

Many Mossari planters can last 30 days or longer between refills, but actual refill timing will vary depending on:

• Plant type and size

• Root system

• Substrate

• Light exposure

• Temperature

• Humidity

• Seasonal growth

A larger or faster-growing plant may use water more quickly.

Choosing a Substrate

Use a substrate that can absorb moisture while still allowing airflow around the roots.

Avoid tightly packed, heavy soil that stays waterlogged. A lighter, well-draining mix generally works best for a self-watering setup.

Choosing a Plant

Self-watering planters work especially well for plants that prefer consistently moist substrate.

Plants that prefer to dry out fully between waterings may require a more airy substrate or less frequent reservoir refills.

Routine Care

• Refill the reservoir when the water level is low.

• Check the substrate occasionally during the first few weeks.

• Adjust the substrate if it stays excessively wet or dries out too quickly.

• Clean the reservoir periodically to remove mineral buildup or residue.

• Flush the planter with plain water occasionally if you regularly add liquid plant food.

Troubleshooting

The substrate is not getting moist.

Make sure the wick reaches the water and extends upward into the soil or root zone. Water the planter from the top once to restart the wicking process.

The substrate stays too wet.

Use a more airy, well-draining substrate. You may also allow the reservoir to remain empty briefly before refilling it.

The plant is using water faster than expected.

This is normal for larger plants, fast-growing plants, or planters placed in warm or bright areas. Refill the reservoir as needed.

There is residue inside the reservoir.

Mineral deposits and fertilizer residue can accumulate over time. Rinse the reservoir with water and wipe it clean periodically.

Need More Help?

For additional setup videos and product information, visit:

[Insert support-page link here]